본 제품은 ESD(전자배송) 상품입니다.

 본 제품은 실물 배송이 아닌 전자 배송 상품입니다. 주문 및 결제를 완료하시면, 입력하신 Email 주소로 시리얼 넘버가 배송됩니다. 신용카드로만 결제가 가능하며 배송 여부와 관계없이 주문 후 취소나 변경은 불가능합니다.

본 제품은 Softube Modular 유저만 사용할 수 있는 제품으로, 계정에 Softube Modular 제품의 보유 여부를 확인할 수 있는 화면의 캡쳐를 soundgear@ssoundgear.com 으로 보내어 제품 구입 가능 여부를 확인하십시오.

배송 소요시간

 실시간 전자배송 : 최대 30분

 (일반) 전자배송 : 영업일 기준 2시간~24시간. 단, 제조사 사정에 의해 2~3일 정도 지연될 수 있음.

등록방법 안내

iLok 인증 시, www.ilok.com의 계정이 필요합니다.

Intellijel Korgasmatron II

 

Taking inspiration from a classic Japanese synth, Intellijel Korgasmatron II is a dual voltage controlled filter which can also be used as a limited oscillator. It has a completely independent six mode filter on each side. The filters can be blended to taste with the Xfade knob. Korgasmatron II is an add-on module for use with Modular.

 

While Korgasmatron II takes its name from a classic Japanese synth released in the early 80s, it’s far from a clone. Korgasmatron II offers much more grit and flexibility than its predecessor.

 

Very impressive! I was making quite complex patches with modules cross modulating each other and the results were very close to what I get on my real hardware.

Danjel van Tijn,founder of Eurorack manufacturer Intellijel

 

Korgasmatron II has a completely independent six mode filter output on each side which are selected via a rotary switch. It also has a special overdrive feature that enables the output signal to be soft or hard clipped depending on hard you drive the input signal. This is controlled via the input amp which starts clipping when you put the knob past 12 o’clock (assuming an standard 10 Vpp waveform). The hard/soft clipping differences are subtle on simple waveforms sources and dramatic on more complex sources (such as chords).

Just like the original hardware, the Intellijel Korgasmatron II can go from clean and precise to howling and agressive, from classic MS-20 type sounds to totally new territory, all depending on how you tweak the front panel controls.

 

In Short

• Dual filter + Xfade
• Six filter types per filter (LP 1-pole, LP 2-pole, BP 1-pole, HP 2-pole, HP 1-pole, BR 1-pole)
• Both filters track 1v/oct over 3-4 octaves (can be used as a limited VCO)
• Switch to configure serial or parallel routing
• Output soft and hard clipping
• Resonance soft clipping control (Q drive)
• Requires Modular